Printek PrintMaster 850 Series User Manual
Page 62
IBM Proprinter Emulation
56
Vertical Tab
VT
Causes the current line to be printed, and then advances the paper to the next vertical tab stop. If no vertical
tab stops are set, then a line feed is done instead. If “Auto CR” is set to “On” in the interface setup menu, a
carriage return will also be performed.
Control code:
VT
Hexadecimal:
0B
Set Vertical Tab Stops
ESC B n1 n2 ... nx NUL
Clears all currently set vertical tab stops, and sets new tab stops at line n1, n2, n3, etc. 1
≥
n
≥
255. The tab
stops must be presented in ascending order. The NUL character, or any tab stop value less than the
preceding one, terminates the sequence. The tab stop settings are based on the current line spacing.
Changing the line spacing after the tab stops are set will not affect the position of the tab stops. The first line
is line one.
ESC B NUL or ESC R will clear all currently set vertical tab stops, leaving no vertical tab stops set.
Example: The following escape sequence will set vertical tab stops at line 7, 13, and 25. If line spacing is
currently 6 lpi, this will result in tab stops one inch, two inches, and four inches from the top of the form.
Escape Sequence:
ESC
B
7
13
25
NUL
Hexadecimal:
1B
42
07
0D
19
00
Horizontal and Vertical Tabs
Reset Horizontal and Vertical Tab Stops
ESC R
Clears all currently set horizontal tab stops, and returns to default horizontal tab stops. Default horizontal tab
stops are set at every eighth column, i.e. column 9, 17, 25, 33, 41, etc. Clears all currently set vertical tab
stops.
Escape Sequence:
ESC
R
Hexadecimal:
1B
52
Horizontal Margins
Printing is allowed only within the left and right margins. Exceeding the right margin will cause line wrap,
setting the current print position to the left margin and advancing the paper one line.
Set Left and Right Margin
ESC X n1 n2
Sets the left margin to column n1 and the right margin to column n2 at the current character spacing.
0
≥
n1
≥
255, 0
≥
n2
≥
255. If character spacing is changed after setting the margins, the position of the margins
will not change.