Precor C842i - Manual (Page 67)

C846i/C842i Recumbent Cycle Assembly Guide 1
Thank you for choosing Precor. For proper installation, please read this guide
thoroughly and follow the assembly instructions. If you do not assemble the
C846i/C842i Recumbent Cycle according to these guidelines, you could void
the Precor Limited Warranty.
Obtaining Service
You should not attempt to service the recumbent cycle except for maintenance
tasks as described in the Product Owner’s Manual. If any items are missing,
contact your dealer. Should you need more information regarding customer
support numbers or a list of Precor authorized service centers, visit the Precor
website at www.precor.com/contact.
Unpacking the Equipment
The unit is shipped on one pallet. Ask for help from two or more people to
unpack and assemble the recumbent cycle.
Required Tools
• Wire tie cutter
• One
³⁄₄
-inch combination wrench (open-end or box)
Installation Requirements
Follow these installation requirements when assembling the unit:
• Assemble the unit near the location where you plan to
use it.
• Provide ample space around the unit.
Open space around the unit allows for easier access.
• Set up the recumbent cycle on a solid, flat surface.
A smooth, flat surface under the unit helps keep it level. A level unit has
fewer malfunctions.
• Open the box and assemble the components in the sequence
presented in this guide.
• Leave room for adjustments.
Tighten fasteners (bolts, nuts, and screws) so the unit is stable, but
leave room for adjustments. Do not fully tighten fasteners until instructed
to do so.
• If you plan to move the unit, obtain help and use a hand truck. Do not
grasp any plastic parts while lifting or moving the unit. The plastic parts
are not capable of supporting the weight of the unit and they may break.