Philips DVD170AT - Manual (Page 7)

Use the NTSC/PAL switch on the rear of the player to set the
player menu according to the standard used by your TV set.
To activate the new setting, the player needs to be switched
off and on again.
NOTE
- The video output standard for video CD and DVD-Video discs
must correspond to the disc being played.
To listen to the player sound directly through headphones,
plug the headphone into the headphone jack on the front of
the player. Adjust the volume as desired with the headphone
volume control.
1 Plug the feed end of the power cord supplied into the
Power connector on the rear of the player.
2 Plug the supply end of the cord into an AC outlet.
NOTE
- The player automatically adjusts to the local AC voltage.
- When the player is in the “OFF” position, it still consumes
some power. If you wish to disconnect your player comple-
tely from the power supply, pull the plug from the AC Outlet.
CAUTION
Only qualified service personnel should remove the
cover or attempt to service this appliance.
LOADING THE BATTERIES
1 Open the battery compartment cover.
2 Insert two ‘AAA’ (R03) batteries as indicated inside the bat-
tery compartment.
3 Close the cover.
CAUTION
Do not mix old and new batteries, and NEVER mix dif-
ferent types of batteries (standard, alkaline, recharge-
ables, etc.).
INFRARED REMOTE CONTROL
CONNECTING THE POWER SUPPLY
HEADPHONES
NTSC/PAL SETTING
english
13
STANDARD CONNECTIONS