Philips cBright 2 Series - Manual (Page 17)

Note: A(audio)/V(video)-mute can only be selected with the
AV mute button on the projector or on the remote control.
A/V mute then appears on the screen.
For example:
The following adjustments procedures follow a slightly
different sequence of actions, or may need some further
explanation.
Digital Zoom
Digital Zoom is used to enlarge a part of the picture.
1. Press Menu.
–
The menu bar will appear.
Display is highlighted and its sub menu is shown.
2. Use Cursor Control to move the cursor to Digital Zoom.
3. Select On to switch Digital Zoom on.
• Press OK to continue, or
• Press Menu to exit and continue with the previous Zoom
settings.
4. Use the zoom target to select centre of the screen area you
wish to enlarge.
• Press OK to confirm.
5. Use the Magnification slider to adjust the Zoom factor.
• Press OK to confirm and exit the menu.
6. Use Cursor Control to select another section of the enlarged
area (Panning).
Note: By pressing the D(igital) Zoom button on the remote
control you enter directly into the zoom centre selection
screen (step 4). When Digital Zoom is already active,
pressing the D(igital) Zoom button will show the
Magnification slider; pressing the D(igital) Zoom button
twice will turn off Digital Zoom.
Horizontal size
The Horizontal size function is used to size a computer image to
make it fit the projected picture. When the OSD menu is active
and the horizontal size option is selected, the level will be
indicated graphically on a linear scale (slider).
Shift
The Shift function adjusts the computer image in horizontal and
vertical direction to centre it on the screen. This function is only
active when Auto image is set to OFF.
1. Press Menu.
–
The menu bar appears
on the screen.
Display is highlighted
and its sub menu is
shown.
2. Use Cursor Control to
move the cursor to
Shift.
3. Press OK to activate
Shift.
4. Use Cursor Control to
position the computer
image.
5. Press OK to confirm and
store the adjustment.
6. If required, select the
next item to be adjusted
or press MENU to exit.
Auto Image
The Auto Image function automatically sizes and positions the
image to fit optimally in the screen picture. In addition it takes
care for phase adjustment. It does not affect the selected
picture format. When Auto Image is set to ON, the Horizontal
size, Shift and Phase options are greyed out.
Move pointer to position the image.
Press OK key when done.
Shift
Display
Digital Freeze
Digital Zoom
Magnification
Auto Image
Horizontal size
Phase
Shift
Shift is used to adjust the position of the image.
Press OK key to activate Shift.
Picture Audio Settings
Data
A/V Muted
8. Operation
17
Display and picture control