Polycom Instructor RP Version 1.0 - Manual (Page 21)

Install the Software and Complete the Calibration
15
Install the Software and Complete the Calibration
If you have an integrated computer connected to your Polycom Instructor RP system, install the Polycom
Instructor Tools software on it.
If you do not have an integrated computer, skip
this step.
The Polycom Instructor Tools software is on the
Polycom CD. You simply need to insert the CD
into the integrated computer and then follow the
Setup Wizard.
Install the SMART Board software.
The SMART Board software is on the SMART
CD. You simply need to insert the CD into the
integrated computer and then follow the Setup
Wizard.
Calibrate the touch screen for the SMART interactive whiteboard.
To calibrate the touch screen for the SMART
interactive whiteboard:
1. Press the SMART Board button on the
SMART tray.
2. Select Orient.
3. Follow the on-screen instructions, making
sure you press your finger squarely on each
crosshair.
For more information, refer to the “Orienting
the Interactive Whiteboard” section of the
Rear Projection SMART Board 3000i Installation
Guide.
4. Press or draw on the screen with your finger
to check that the calibration worked
correctly.
1
2
SMART
3
SMART Board button