Polycom Instructor RP Version 1.0 - Manual (Page 19)

Calibrate the Annotation Box
13
Calibrate the touch screen for Camera 3.
Camera 3 is typically the VCR or DVD player.
However, even if you do not have a VCR or DVD
player connected to your system, you must still
calibrate the touch screen for Camera 3. (You
must calibrate each available camera and video
source because the system stores separate
calibration data for each.)
To calibrate the touch screen for Camera 3:
1. On the Polycom remote control, press
Camera and select 3.
2. Pick up a pen from the SMART tray.
3. Press the Keyboard button on the
SMART tray to access the calibration screen.
4. Use the pen to touch the center of the
crosshair on the upper left of the screen.
If the PIP appears on the screen, use the
remote control to turn it off because it can
hide the crosshairs.
5. Use the pen to touch the center of the
crosshair on the lower right of the screen.
6. Use the pen to touch the center of the
crosshair on the upper right of the screen.
7. Draw on the screen to check that the
calibration worked correctly.
Calibrate the touch screen for Camera 4.
Camera 4 is typically the integrated computer.
However, even if you do not have an integrated
computer, you must still calibrate the touch
screen for Camera 4 because it will be used for the
annotation box whiteboard instead. (You must
calibrate each available camera and video source
because the system stores separate calibration
data for each.)
2
CALIBRATE TOUCH SCREEN
TOUCH UPPER LEFT TARGET
CALIBRATE TOUCH SCREEN
TOUCH LOWER RIGHT TARGET
CALIBRATE TOUCH SCREEN
TOUCH UPPER RIGHT TARGET
3
Note If you add a PC or laptop after you have
already performed this step, or you
switch to a different PC or laptop, you
may need to perform this step again to
recalibrate the touch screen.