PACKARD BELL C3 - Manual (Page 12)

Packard Bell EasyNote C3 Disassembly Manual 12
Removing the LCD Panel
To remove the LCD panel, first remove the LCD module (see Removing the LCD Module ),
then perform the following steps:
1. Use a pin to remove the rubber covers on the LCD module as shown in Fig. 15
2. Unscrew all screws as shown in Fig. 15 and release carefully the LCD cover.
Fig. 15 Removing the rubber covers & screws on the LCD Module
3. Remove the inverter board after unscrewing the screw and disconnecting all
connectors as shown in Fig. 16 .
Fig. 16 Removing the Inverter Board
4. Carefully lift up the LCD panel.
5. Remove the screws on both sides of the LCD panel in order to release the LCD
hinges as shown in Fig. 17
A=M2.5x5 silver
B=M2.5x6 black
M2x3 copper