PACKARD BELL C3 - Manual (Page 10)

Packard Bell EasyNote C3 Disassembly Manual 10
Removing the LCD Module
To remove the LCD Module first remove the battery (see Removing the Battery ) and
remove the keyboard (see Removing the Keyboard ), then perform the following steps:
1. Remove the screws retaining the Heat Plate as shown in Fig. 11
Fig. 11 Removing the screws retaining the Heat Plate
2. Flip over the base unit and release the screws retaining the LCD Module.
Fig. 12 Bottom screws retaining the LCD Module
3. Release the screws on the system rear side as shown in Fig. 13
Fig. 13 Rear screws retaining the LCD Module
M2.5x7 silver
M2.5x9 silver
M2.5x9 silver