Polycom SoundStation IP 7000 - Manual (Page 13)

Setting Up Your Phone
1 - 7
Before you connect two phones together, make sure you have the optional
Multi-Interface Module Package (containing a Multi-Interface Module, 12-foot
Network Cable (10-pin), Power Adapter, and Regional Power Cord) and the
optional Console Interconnect Cable.
The following figure shows how to connect two phones to the network using
AC power.
To connect two phones to an AC power source:
1. Connect the 12-foot Network Cable (10-pin) to the LAN jack on the first
phone.
2. Connect the other end of the 12-foot Network Cable (10-pin) to the
Multi-Interface Module.
3. Connect the 25-foot Network Cable to the Multi-Interface Module.
4. Connect the other end of the 25-foot Network Cable to an available
LAN port on the wall or hub/switch device port.
5. Connect the Power Adapter to the Multi-Interface Module.
Multi-Interface
Module
Console
Interconnect Cable
12-foot
Network Cable (10-pin)
25-foot
Network Cable
Power Adapter
6
1
2
5
7
3
4
Warning Make sure you connect the two phones and the Multi-Interface Module before you
connect the Power Adapter (with the attached Regional Power Cord) to the wall
outlet.