Paradyne ACCULINK 3151 CSU - Manual (Page 8)

6
Table 2. Network Interface Configuration Options (2 of 2)
Option Comments/Description Factory 2 Factory 1
NET PLB:
Enab
N/A Network-initiated PLB allows PLB to be
NET PLB:
Disab
N/A Network-initiated PLB allows PLB to be
controlled by FDL PLB messages.
N/A
62411
Enforces ONEs density protection per
BitStuff:
N/A
Part68
Enforces ONEs density protection per
AT&T TR 62411, ANSI T1-403, and
FCC P t 68 T
h i l P bli ti
BitStuff:
Disab
AT&T TR 62411, ANSI T1 403, and
FCC Part 68 Technical Publication.
AIS AIS
KeepAlive:
One (Framed
All Ones)
One (Framed
All Ones)
Specifies the keep alive signal to send
to the network interface on a failure of
KeepAlive:
NetLp
(Loopback of
network signal)
NetLp
(Loopback of
network signal)
to the network interface on a failure of
the DTE signal.
Yellow:
Enab Enab Transcodes and sends Yellow signal to
the network on receiving Yellow from
Yellow:
Disab Disab
g
the network on receiving Yellow from
DTE.
Circuit Ident:
Edit Edit
Specifies the transmission vendor’s Circuit Ident:
Clear Clear
Specifies the transmission vendor s
circuit identifier.
CRC PThru
Enab Enab
Determines whether framing bits are
CRC PThru
(Passthrough):
Disab Disab
Determines whether framing bits are
passed to the DTE.
Table 3. General Configuration Options
Option Factory 1 Factory 2 Comments/Description
Tst Timeout:
Enab Enab Specifies whether user-initiated
tests are limited by the Tst Duration
Tst Timeout:
Disab Disab
tests are limited by the Tst Duration
configuration option.
10 10
Tst Duration:
Up Up
Specifies in minutes the duration of
Tst Duration:
Down Down
Specifies in minutes the duration of
user-initiated tests.
Save Save
Table 4. User Interface Configuration Options (1 of 4)
Option Factory 1 Factory 2 Comments/Description
Self-Test:
Enab Enab
Allows bypass of self-test on
Self-Test:
Disab Disab
Allows bypass of self-test on
initialization.