Installation, On off – Pitco Frialator Solstice Gas Fryer with Filter SFSG6H User Manual
Page 12
![background image](/manuals/184897/12/background.png)
INSTALLATION
8
L20-332, rev. 1 (05/11)
ON
OFF
Solid State
I/0 ON/OFF
Switch
Solid State Melt
Switch
1.8. INITIAL
ADJUSTMENTS
After your appliance has been properly installed as described in the installation section of this
manual, it will need to be adjusted to ensure that it will perform as designed. A qualified person must
perform these adjustments.
To perform these adjustments the following tools will be needed:
Manometer
Digital Thermometer (Temperature Probe)
DC
Microammeter
1.8.1. FILLING THE APPLIANCE
Refer to the following procedure to fill the cook tank prior to operation.
1. Ensure that the drain valve is closed.
2. Fill the tank with oil/shortening until the oil/shortening reaches the level line(s). Never let the
oil/shortening level go below the MIN LEVEL mark stamped on the tank.
1.8.2. LIGHTING
INSTRUCTIONS
There is nothing to manually light on the electronic ignition system. Pilot ignition is performed and
controlled by the electronic ignition system. Refer to the following instructions to light the
appliance.
1. Open the gas supply valves to the appliance.
2. Turn the gas valve knob to the ON position.
3. Turn the controller on.
Solid State Thermostat:
Assure the Melt switch is in the correct position.
Turn the I/0 (ON/OFF) switch to the I (ON) position
Computer and Digital Control:
Press the
* button to turn the controller on.
*The specified button may appear slightly different then shown. Refer to the
operator’s manual for your appliance’s specific control type to determine the exact
appearance of each button and display.
4. The main burners will light and be controlled by the thermostat.
WARNING
Oil/shortening must completely cover the heat tubes at all times while appliance is on.
CAUTION
This appliance is not designed for cooking with water. Fill with oil/shortening only.
WARNING
During operation there is an open flame inside this appliance. The unit may get hot enough to
set near by materials on fire. Keep the area around the appliance free from combustibles.