Pioneer VSX-917V-S/-K - Manual (Page 7)

5 minute guide 02
7
En
English
Français
Deutsch
Nederlands
Italiano
Español
Chapter 2:
5 minute guide
Introduction to home theater
Home theater refers to the use of multiple
audio tracks to create a surround sound effect,
making you feel like you’re in the middle of the
action or concert. The surround sound you get
from a home theater system depends not only
on your speaker setup, but also on the source
and the sound settings of the receiver.
This receiver will automatically decode
multichannel Dolby Digital, DTS, or Dolby
Surround sources according to your speaker
setup. In most cases, you won’t have to make
changes for realistic surround sound, but
other possibilities (like listening to a CD with
multichannel surround sound) are explained in
Listening to your system on page 28.
Listening to Surround Sound
With the following quick setup guide, you
should have your system hooked up for
surround sound in no time at all. In most
cases, you can simply leave the receiver in the
default settings.
• Be sure to complete all connections before
connecting to an AC power source.
1 Connect your DVD player and TV.
See Connecting a DVD player and TV on page 13
to do this. For surround sound, you’ll want to
hook up using a digital connection from the
DVD player to the receiver.
2 Connect your speakers and place them for
optimal surround sound.
See Connecting the speakers on page 19.
Where you place the speakers will have a big
effect on the sound. Place your speakers as
shown below for the best surround sound
effect. Also see Hints on speaker placement on
page 20 for more on this.
3 Plug in and switch on the receiver,
followed by your DVD player, subwoofer and
TV.
Make sure you’ve set the video input on your
TV to this receiver. Check the manual that
came with the TV if you don’t know how to do
this.
4 Use the on-screen automatic MCACC
setup to set up your system.
See Automatically setting up for surround
sound (MCACC) below for more on this.
5 Play a DVD, and adjust the volume.
Make sure that DVD is showing in the
receiver’s display. If it isn’t, press DVD on the
remote to set the receiver to the DVD input. 1
There are several other sound options you can
select. See Listening to your system on page 28
for more on this. 2
Note
1 You may need to set your DVD player to output Dolby Digital, DTS and 88.2 kHz/96 kHz PCM (2 channel) audio (see your DVD
player’s manual for more on this).
2 Depending on your DVD player or source disc, you may only get 2 channel sound. In this case, the listening mode must be set
to
STANDARD (see Listening in surround sound on page 28 if you need to do this) if you want multichannel surround sound.
Front
speaker
( L)
Surround
speaker (
LS)
Surround
speaker (
RS)
Surround back
speaker (
SBL)
Surround
back
speaker (
SBR)
Center
speaker
(
C)
Subwoofer ( SW)
Listening
position
Front
speaker
(
R)
VSX-917V.book.fm Page 7 Wednesday, December 20, 2006 3:04 PM