Pioneer VSX-917V-S/-K - Manual (Page 12)

Connecting up 03
12
En
About the video converter
When the video converter is enabled, all analog
video sources are output through all of the
MONITOR VIDEO OUT jacks (HDMI and high-
definition progressive component video cannot
be converted). 1 See Digital Video Converter
Setup on page 64 to switch the video converter
on or off.
If several video components are assigned to
the same input function (see The Input Assign
menu on page 61), the converter gives priority
to component, S-video, then composite (in that
order).
Note
1 You must connect your monitor/TV to the receiver’s HDMI/component video outputs when connecting these video sources. If
the video signal does not appear on your TV or plasma display, try adjusting the resolution settings on your component or display.
Note that some components (such as video game units) have resolutions that may not be converted. In this case, use an (analog)
S-video or composite connection.
This product incorporates copyright protection technology
that is protected by U.S. patents and other intellectual
property rights. Use of this copyright protection
technology must be authorized by Macrovision
Corporation, and is intended for home and other limited
consumer uses only unless otherwise authorized by
Macrovision. Reverse engineering or disassembly is
prohibited.
VSX-917V.book.fm Page 12 Wednesday, December 20, 2006 3:04 PM