Pioneer VSX-917V-S/-K - Manual (Page 50)

Controlling the rest of your system 10
50
En
Chapter 10:
Controlling the rest of your
system
Operating other Pioneer
components
Many Pioneer components have SR CONTROL
jacks which can be used to link components
together so that you can use just the remote
sensor of one component. When you use a
remote control, the control signal is passed
along the chain to the appropriate
component. 1
Note that if you use this feature, make sure that
you also have at least one set of analog audio or
video jacks connected to another component
for grounding purposes.
Setting the remote to control
other components
Most components can be assigned to one of
the
MULTI CONTROL buttons using the
component’s manufacturer preset code stored
in the remote.
However, please note that there are cases
where only certain functions may be
controllable after assigning the proper preset
code, or the codes for the manufacturer in the
remote control will not work for the model that
you are using. 2
Note
• You can cancel or exit any of the steps by
pressing RECEIVER. To go back a step,
press RETURN.
• After one minute of inactivity, the remote
automatically exits the operation.
Note
1 • If you want to control all your components using this receiver’s remote control, refer to Controlling the rest of your system on
page 50.
• If you have connected a remote control to the CONTROL IN jack (using a mini-plug cable), you won’t be able to control this
unit using the remote sensor.
CONTROL
OUT
IN
CONTROL
OUT
IN
Receiver
Remote
control
unit
Other Pioneer products
with
CONTROL terminals
Connect to CONTROL
terminal of other
Pioneer products
2 • TV codes (for example, codes for TV, CATV, Satellite TV or DTV) can only be assigned to the TV/SAT or TV CTRL button.
• If you assign the FM or AM function to another component, you will have to reassign it to the Pioneer preset code to use this
receiver’s built-in tuner.
VSX-917V.book.fm Page 50 Wednesday, December 20, 2006 3:04 PM