Pioneer VSX-917V-S/-K - Manual (Page 68)

Additional information 13
68
En
Switching the speaker
impedance
We recommend using speakers of 8 Ω with
this system, but it is possible to switch the
impedance setting if you plan to use speakers
with a 6
Ω impedance rating.
• With the receiver in standby, press 
STANDBY/ON while holding down the
SPEAKERS button.
Each time you do this, you switch between the
impedance settings:
• SP 6 OHM – Use this setting if your
speakers are rated at 6
Ω.
• SP 8 OHM – Use this setting if your
speakers are rated at 8
Ω or more.
Changing the TV format setting
If the System Setup menu is not displayed
correctly, it may be that the TV system is set
incorrectly for your country or region.
• With the receiver in standby, press 
STANDBY/ON while holding down the
SIGNAL SELECT button.
The display shows the new setting (
PAL or
NTSC).
Specifications
Amplifier section
• Continuous power output (stereo)
Front . . . . . . . . . . . . . . . . . . . . . . . 100 W + 100 W
(DIN 1 kHz, THD 1.0 %, 8
Ω
)
• Rated power output
(surround / 20 Hz to 20 kHz, THD 0.08 %, 8
Ω)
Front . . . . . . . . . . . . . . . . . . . . . .90 W per channel
Center . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 90 W
Surround. . . . . . . . . . . . . . . . . . .90 W per channel
Surround Back . . . . . . . . . . . . . .90 W per channel
• Rated power output
(surround / 1 kHz, THD 1 %, 8
Ω)
Front . . . . . . . . . . . . . . . . . . . . .110 W per channel
Center . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 110 W
Surround. . . . . . . . . . . . . . . . . .110 W per channel
Surround Back . . . . . . . . . . . . .110 W per channel
Audio section
• Input (Sensitivity/Impedance)
CD, DVR/VCR, CD-R/TAPE/MD,
DVD/LD, TV/SAT. . . . . . . . . . . . . . . .200 mV/47 k
Ω
• Frequency response
CD, DVR/VCR, CD-R/TAPE/MD, DVD/LD,
TV/SAT. . . . . . . . . . . . . . . 5 Hz to 100 000 Hz dB
• Output (Level/Impedance)
DVR/VCR REC, CD-R/TAPE/
MD REC . . . . . . . . . . . . . . . . . . . . . 200 mV/2.2 k
Ω
• Tone control
Bass . . . . . . . . . . . . . . . . . . . . . . . .±6 dB (100 Hz)
Treble . . . . . . . . . . . . . . . . . . . . . . .±6 dB (10 kHz)
Loudness . . . . . . +10 dB/+5 dB (100 Hz/10 kHz)
(at volume level –50 dB)
• Signal-to-Noise Ratio DIN (Continuous
rated power output / 50 mW)
CD, DVR/VCR, CD-R/TAPE/MD,
DVD/LD, TV/SAT. . . . . . . . . . . . . . . . . 88 dB/64 dB
Video Section
• Input (Sensitivity/Impedance)
DVR/VCR, DVD/LD, TV/SAT................ 1 Vp-p/75
Ω
• Output (Level/Impedance)
DVR/VCR, MONITOR OUT.................. 1 Vp-p/75
Ω
VSX-917V.book.fm Page 68 Wednesday, December 20, 2006 3:04 PM