Pioneer VSX-917V-S/-K - Manual (Page 67)

Additional information 13
67
En
English
Français
Deutsch
Nederlands
Italiano
Español
HDMI
Resetting the main unit
Use this procedure to reset all the receiver’s
settings to the factory default. Use the front
panel controls to do this.
1 Switch the receiver into standby.
2 While holding down the TONE button,
press and hold the  STANDBY/ON button
for about three seconds.
3 When you see RESET? appear in the
display, press ENTER.
OK? shows in the display.
4 Press SETUP to confirm.
OK appears in the display to indicate that the
receiver has been reset to the factory settings.
The SR cable is connected, but
the connected components
can’t be operated with the
remote. • Reinsert the SR cable, making sure it’s connected to the right jack (see Using this
receiver with a Pioneer plasma display on page 59).
• Make sure an analog connection has been made between the units.
• This feature only works with Pioneer products.
The display is dark or off. • Press DIMMER on the control repeatedly to return to the default.
USB mass storage device is
not recognized by the receiver. • Try switching the receiver off, then on again.
• Make sure you have completely inserted the USB connector to this receiver.
• Check that the memory format is FAT16 or FAT32 (FAT12, NTFS and HFS are not
supported).
• USB devices with an internal USB hub are not supported.
USB ERR3 shows in the display
when connecting a USB
device. • If this message continues to appear after going through all the checks in
Important on page 34 of USB playback, take the unit to your nearest Pioneer
authorized service center or your dealer for servicing.
Can’t play audio files. • The WMA or MPEG-4 AAC files were recorded using DRM (digital rights
management), or the bit rate/sampling rate is not compatible (see Compressed
audio compatibility on page 35). This is not a malfunction.
Problem Remedy
Symptom Remedy
No picture or sound. • If the problem still persists when connecting your HDMI component directly to your
monitor, please consult the component or monitor manual or contact the
manufacturer for support.
No picture. • Depending in the output settings of the source component, it may be outputting a
video format that can’t be displayed. Change the output settings of the source, or
connect using the component, S-video or composite jacks.
OSD does not appear. • The OSD will not appear if you have connected using the HDMI output to your TV.
Use component, S-video, or composite connections when setting up the system.
No sound, or sound suddenly
ceases. • Since the HDMI audio signal is sent through this receiver to your TV, you need to
make separate connections for audio if you want to hear your HDMI component
through this system. See Connecting using HDMI on page 56 for more on this.
• If you’ve made separate connections for audio, make sure you have assigned the
analog/digital jack(s) to the corresponding HDMI input for the component. See
Assigning the HDMI inputs on page 62 to do this.
• Check the audio output settings of the source component.
VSX-917V.book.fm Page 67 Wednesday, December 20, 2006 3:04 PM