Philips LC4242 - Manual (Page 9)

Horizontal angle (horizon)
•
Adjust or correct a possible tilted picture by turning the
horizontal adjusters to the desired position.
Up: turn the adjuster(s) to the left.
Down: turn the adjuster(s) to the right.
• Use the FOCUS Ring and ZOOM Ring to readjust the focus
and size of the image.
Vertical keystone correction
If projector and screen are not properly placed, the picture will
be distorted, producing a keystone image.
Vertical keystone correction allows you to
correct picture distortion of the vertical
keystone type by internal scaling. This
correction function is accessible through the
‘Keystone Correction’ option in the ‘Display’ submenu of the On
Screen Display (OSD) menu. For details see the explanation in
‘Display and Picture Control’.
Moving the projector
1. Press the STANDBY/ON/OFF button to switch off the
projector. The standby indicator lights up red.
2. Wait until the cooling fan has stopped (about 3 minutes after
the projector has been switched off) and disconnect the
mains lead and all other cables.
3. Make sure the lens is turned back in to prevent damage to
the lens.
4. Put the lens cap back in place to prevent dust, dirt or other
contamination from harming or damaging the front of the
projector lens when moving the projector.
Note: Never place the projector on the side where the
connections are located.
Inserting the batteries in the compact remote control
1. Push and slide the lid in the direction of the arrow.
2. Install two ‘AAA’ batteries as indicated inside the battery
compartment.
3. Replace the lid and snap it into place.
Note: The maximum range of the remote control is
approximately 15 m (± 50 feet).
Inserting the batteries in the trackball remote control
(optional)
1. Push and slide the lid in the direction of the arrow.
2. Install three ‘AA’ batteries as indicated inside the battery
compartment.
3. Replace the lid and snap it into place.
Caution!
Do not mix old and new batteries (also never mix alkaline and
manganese batteries).
Note: The maximum range of the remote control is
approximately 20 m (± 65 feet).
P u s h
P u s h
OK
Menu
Data Lamp
Mute AVMute
RC
Volume
Standby
Video
On/Off
OK
Menu
Data Lamp
Mute AVMute
RC
Volume
Standby
Video
On/Off
Data in
S-Video in
Video in
Audio
Audio
out
Audio
out
L R
Data in
S-Video in
Video in
Audio L R
Power
Data Audio
Video
USB in USB in USB out USB out
Keystoned Image
OK
Menu
Data Lamp
Mute
AVMute
RC
Volume
Standby
Vide o
On/Off
OK
Menu
Data Lamp
Mute AVMute
RC
Volume
Standby
Video
On/Off
Data in
S-Video in
Video in
Audio
Audio
out
Audio
out
L R
Data in
S-Video in
Video in
Audio L R
Power
Data Audio
Video
USB in USB in USB out USB out
6. Set Up
9