Philips AMBX SGC5101BD - Manual (Page 37)

37
If the peripherals still not respond when you started the scene, your peripherals might be in Standby mode. To
awake your peripherals, press the On/Off button on your hardware (Wall Washer & Controller or Speaker
Lights) so the LED-light in the button turns on.
I Cannot Add a New Scene
It is not possible to add a scene to the Scenes Selector, you can only customize an existing variable scene.
When you install the software, the
Scenes Selector already contains 15 scenes, 10 variable scenes and 5
preset scenes. You recognize the preset scenes by the icon .
To change a variable scene:
1. Select the Scene Settings tab.
The 'Scene Settings' screen appears.
2. Select the scene that you would like to customize in the Scenes Selector .
The settings of the scene become visible in the Scene Overview.
3. Change the Scene Settings.
4. Click the Save Changes button to replace the selected scene in the Scenes Selector.
5. Click the OK button to confirm.
Maintenance
Cleaning the Peripherals
To clean your Peripherals use a soft, damp cloth . Do not use alcohol, alcohol based or any corrosive
detergent to clean your Peripherals. These detergents may damage the paint or change its color.