Polycom SpectraLink DCE201 User Manual
Page 51
Safety Information
1725-36027-001_C.doc
51
SAR limit set by the FCC is 1.6W/kg.
using standard operating positions specified by the FCC with the
phone transmitting at its highest certified power level in all tested
frequency bands. Although the SAR is determined at the highest
certified power level, the actual SAR level of the phone while
operating can be well below the maximum value. This is because the
phone is designed to operate at multiple power levels so as to use
only the power required to reach the network. In general, the closer
you are to a wireless base station antenna, the lower the power
output. Before a phone model is available for sale to the public, it
must be tested and certified to the FCC that it does not exceed the
limit established by the government-adopted requirement for safe
exposure. The tests are performed in positions and locations (e.g., at
the ear and worn on the body) as required by the FCC for each model.
While there may be differences between the SAR levels of various
phones and at various positions, they all meet the government
requirement for safe exposure. The FCC has granted an Equipment
Authorization for this model phone with all reported SAR levels
evaluated as in compliance with the FCC RF emission guidelines. SAR
information on this model phone is on file with the FCC and can be
found under the Display Grant section of
er searching on FCC ID IYGSNP2400.
Additional information on Specific Absorption Rates (SAR) can be
found on the Cellular Telecommunications Industry Association
(CTIA) web-site at
.
The only authorized headsets that may be utilized with the SNP2400
are those obtainable from SpectraLink or its reseller partners.
The measured SAR of the SNP2400 wireless telephone is
0.61W/kG @ 2462 MHz (head) 0.0379W/kG @ 2412 MHz (body).
Handset operation normal position
Hold the handset as you would any other telephone, with the
earpiece to your ear and speak into the microphone. The internal
antenna is then positioned properly.
4
In the United States and Canada, the SAR limit for mobile phones used by the public is 1.6 watts/kg (W/kg) averaged over one
gram of tissue. The standard incorporates a substantial margin of safety to give additional protection for the public and to account
for any variations in measurements.