Polaris D7500 - Manual (Page 13)

13
Camera Cable Connection - Carefully connect the supplied Camera Handpiece
Cable between the Camera Handpiece and Control Module as follows:
Do not twist or turn the cable connectors. The handpiece Cable connectors are keyed and
mate straight on with the associated Camera handpiece and Control Module connectors.
INSTALLATION
Camera Handpiece Connection.
1 . Using the gray molded connector
cable end, align the connector key
with the keyway of the Handpiece
connector .
2 . Insert straight into Handpiece
connector until it securely snaps
into place .
Control Module Connection
1 . Using the 10-pin quick disconnect
plug end, align connector key with
the keyway of the mating CAMERA
connector located on the front
panel of the Control Module .
2 . Insert the connector straight into
the mating CAMERA connector
until it securely snaps into place .
handpiece Cable
10-pin Quick
Disconnect Plug
NOTE: In addition to the supplied 15-foot multi-conductor cable, optional 6, 9, 30 and 50-foot
lengths are available from your authorized Air Techniques Dealer at an extra cost.
Connector
Key
Camera
Handpiece
Polaris
handpiece
Cable
Polaris Handpiece Holder with Chair-side Adapter - Installing the
Chair-side Adapter is as easy as deciding on a location for maximum convenience
and securing it to an empty customer-supplied standard Handpiece Holder . Refer
to the illustration below and install the Chair-side Adapter as follows:
1 . Insert Handpiece Holder Adapter (1)
into the wide end of Grip (2) .
2 . Press Grip (2) into the top of the
chosen Handpiece Holder .
3 . Insert Expander (3) into the bottom
of Grip (2)
4 . Insert and push the Joint Connector
Hex Bolt (4) into Expander (3) engaging
the thread of Handpiece Holder Adapter
(1) by turning the Joint Connector Hex
Bolt (4) clockwise .
5 . Using the supplied Short Arm Allen
Wrench (5), tighten Joint Connector
Hex Bolt (4) until the Chair-side Adapter
is secure in the Handpiece Holder .
Handpiece Holder Chair-side Adapter
Assembly
5
1
3
4
Customer-Supplied
handpiece holder and
hanger Bar
2
1 handpiece holder Adapter
2 Grip
3 Expander
4 Joint Connector hex Bolt
5 5/32 Short Arm Allen
Wrench