Philips AW 7250/04S - Manual (Page 5)

Controls Installation
SUPPLY
Battery supply
• Whenever convenient, use the mains supply
if you want to conserve battery life.
• Open the battery compartment and insert
six batteries as indicated , type R20, UM1 or
D-cells.
• Remove the batteries if they are exhausted
or if they will not be used again for a long
time.
The battery supply is switched off when the
set is connected to the mains supply. To
change over to battery supply, pull out the
plug from the MAINS socket.
mains supply
• Check if the mains voltage as shown on the
type plate (on the base of the set)
corresponds to your local mains voltage. If it
does not, consult your dealer or service
organization.
• If the set is equiped with a voltage selector,
set this selector to the local mains voltage.
• Connect the mains lead to the mains socket
(and plug the wall outlet). The mains supply
is switched on.
• To disconnect the set from the mains
completely, withdraw the mains plug from
the wall socket.
IMPORTANT NOTE FOR USERS IN THE U.K.
See page 4
VOLTAGE
SELECTOR MAINS
6 x D-cells - R20 - UM1
5
English
AW 7150/AW 7250/00. page 5
FM 88 • 92 • 96 • 100 • 104 • 108
MHz
MW 530 • 630 • 800 • 1000 • 1300 • 1600
KHz
FM 88 • 92 • 96 • 100 • 104 • 108
MHz
MW 530 • 630 • 800 • 1000 • 1300 • 1600
KHz
HIGH SPEED DUBBING / RECORD
CONTINOUS PLAY
AW 7150
1
RECORD
2
RECORD
HIGH SPEED DUBBING / RECORD
CONTINOUS PLAY
AW 7150
1
RECORD
2
RECORD
S TEREO R ADIO C ASSETTE R ECORDER
S TEREO R ADIO C ASSETTE R ECORDER IOIOIOO IOIOI IOIOI IOIOIOO IOIOIO O IOIOIOO IOIOIOO IOIOIOO IOIOIOO IOIOIOO
IOIOIOO IOIOIOO
IOIOI IOIOI IOIOI IOIOI IOIOI IOIOI
IOOIO IIOI IOIOIOOIOOI IOOIOIIOI IOIOIOOIOOI
IOO IOII
IOOIO II IO IOIOIO IO
IOOIOII
IOOIO II IO IOIOIO IO
DECK 1
DECK 2
DIRECTION
INDICATORS
(AW 7250 only)
PHONES p
VOLUME
TONE TAPE/HI-SPEED
DUBBING/RADIO
MIC
DECK 2
CASS. KNOB
BAND
TUNING
DECK 1
CASS. KNOB