Panasonic CF-T1 - Manual (Page 12)

12
Touchscreen
When needed, the touchscreen can be configured using the following steps.
1
Windows 2000
Select on the taskbar and then select [TouchScreen] or select
[TouchScreen] in [Control Panel] - [Mouse].
Windows XP
Select on the taskbar and then select [TouchScreen] or select
[TouchScreen] in [Control Panel] - [Printers and Other Hardware]
- [Mouse].
2
Make necessary changes.
3
Select [OK].
NOTE
●
For more information about each item
Select at the upper right corner in [Mouse Properties], then, using , select
the item about which you want more information.
●
The double-click speed of the touchscreen can be changed in [Buttons].
Configurating the Touchscreen
B
D
A
C
A. Double click settings
Set the width and height of the double click.
C. Advanced configuration
Set the advanced settings.
B. Test
Test for the “Double click settings”.
D. Calibration & Test
Define the calibration setup. Use this procedure when the cursor does not
appear properly. (Necessary for changes in the alignment of the touch-
screen with visual images or an adjustment of the display resolution.)
Touch the “+” mark on the calibration screen for about one second.
After the calibration procedure is executed (e.g., after the nine “+” marks
are touched), the procedure ends when
Enter Enter Enter Enter is pressed.