PLUS Vision PLUS Piano HE-3200 - Manual (Page 26)

E – 26
Input Selection
Press the desired input selection button.
VIDEO
/YPbPr S-VIDEO RGB DVI
SV CV RGB DVI
S-VIDEO
S-VIDEO
YCbCr
YPbPr
VIDEO
RGB
DVI
Input selection display
S-VIDEO button
A press of the button will switch the input to the S-VIDEO
input signal.
VIDEO/YPbPr button
The source selection display will appear. (If the source
selection display is not displayed, press the button again.)
* [AUTO] is selected at the initial setting.
A press of the SET button causes the source selection
display to disappear and starts an automatic search of
the VIDEO/YCbCr/YPbPr input signal.
* The input display at the [AUTO] setting will be
[Video/YCbCr/YPbPr].
RGB button
A press of this button switches the unit to the RGB input
signal.
DVI button
A press of this button switches the unit to the DVI input
signal.
The input display will remain on for a while before disap-
pearing. To change the duration of the display, see
→ Page
E-41 "On-Screen Display Duration Setting."
VIDEO/YCbCr/YPbPr Signal Selection
The input signal is specified directly and projected.
A press of the VIDEO/YPbPr button displays the source
selection display. (If the source selection display is not
displayed, press the button again.)
Select the signal with the cursor ( ̆̄) button or the
VIDEO/YPbPr button.
A press of the SET button causes the source selection
display to disappear, performs a search for the specified
signal and projects it.
Note:
* When the power is switched on, the input
selection conditions that existed when the
power was switched off will be in effect.
* When a signal is not input to the selected
connector, "No Signal" is displayed.
* When RGB or DVI is selected and "No Sig-
nal" is displayed, check with [Info.] on the
menu.
→ Page E-43 "Viewing the Lamp Timer/
Resolution and Frequency"
When the frequency is displayed as "0 kHz,
0 Hz," there is no signal from the personal
computer.
→ See Page E-20 "Obtaining an
External Output Signal from a Notebook
Computer."
Operation with the Remote Control
AUTO
VIDEO
SOURCE
YCbCr
YPbPr
AUTO
VIDEO
SOURCE
YCbCr
YPbPr
Note:
* When the source selection is specified as
[AUTO], upon switching to the VIDEO/
YCbCr/YPbPr signal, a search for the sig-
nals will be made in order and it may take
a while before the signal is displayed. The
signal can be projected quickly when it has
been specified directly.
* Conversely, for example, when connection
is made to a video system that switches
the input signal from a YCbCr signal to a
YPbPr signal, having previously set the
source selection to [AUTO], another press
of the VIDEO/YPbPr button (i.e., the
SOURCE button on the projector) will per-
form automatic identification of the signal.
Source selection display