Pentax 30 - Manual (Page 60)

58
4
Tak
ing Pi
cture
s
eHJLI CKEK
Pictures are taken continuously while the shutter release button is pressed.
There are two available modes: Continuous Shooting and Multi Continuous Shooting.
1
Press the four-way controller (2)
to display j or _ on the LCD
monitor.
2
Press the shutter release button
halfway.
The focus frame on the LCD monitor will
light green when the camera is in focus.
3
Press the shutter release button.
j
Pictures will be taken continuously while the shutter release button is pressed.
Shooting stops when you remove your finger from the shutter release button.
_ Pictures are taken four frames at a time and saved as a single image.
Continuous Shooting (Continuous Shooting /
Multi Continuous Shooting)
j Continuous Shooting
Images are captured, processed and saved one by one.
_ Multi Continuous Shooting Pictures are taken four frames at a time and saved as a single image.
Playing Back Still Pictures 1p.24
• You can continue shooting until the SD Memory Card is full.
• The interval will vary according to the [Recorded Pixels] and [Quality Level] setting.
• The recorded pixels are fixed at 1280 × 960 in Multi Continuous Shooting mode.
• The flash will not discharge in Continuous Shooting or Multi Continuous Shooting mode.
• Continuous Shooting and Multi Continuous Shooting are not available for
Movie Picture, Panorama Assist, Night-Scene or Night-Scene Portrait mode.
2, 3
1
3
1 0 / 1 0 / 2 0 0 4 1 0 / 1 0 / 2 0 0 4
1 1 : 2 0 1 1 : 2 0
1 0 / 1 0 / 2 0 0 4
1 1 : 2 0