Premio Computer Apollo/Shadowhawk - Manual (Page 128)

BIOS Setup Program
105
Table 66. Peripheral Configuration Submenu (continued)
Feature Options Description
Interrupt
(This feature is displayed
only if Serial Port B is set
to Enabled.)
• IRQ 3
(default)
• IRQ 4
Specifies the interrupt for serial port B, if serial port B is set to
Enabled.
Parallel port • Disabled
• Enabled
• Auto (default) Configures the parallel port.
Auto assigns LPT1 the address 378h and the interrupt IRQ7.
An * (asterisk) displayed next to an address indicates a
conflict with another device.
Mode • Output Only
• Bi-directional
(default)
• EPP
• ECP
Selects the mode for the parallel port. Not available if the
parallel port is disabled.
Output Only operates in AT † -compatible mode.
Bi-directional operates in PS/2-compatible mode.
EPP is Extended Parallel Port mode, a high-speed
bi-directional mode.
ECP is Enhanced Capabilities Port mode, a high-speed
bi-directional mode.
Base I/O address
(This feature is present
only when Parallel Port
is set to Enabled)
• 378 (default)
• 278
Specifies the base I/O address for the parallel port.
Interrupt
(This feature is present
only when Parallel Port
is set to Enabled) • IRQ 5
• IRQ 7
(default)
Specifies the interrupt for the parallel port.
DMA
(This feature is present
only when Parallel Port
Mode is set to ECP) • 1
• 3 (default) Specifies the DMA channel.
Audio Device • Disabled
• Enabled
(default)
Enables or disables the onboard audio subsystem.
For boards with no onboard audio subsystem, this option
does not appear; however, this option does appear if a CNR
card with an audio subsystem is installed.
LAN Device • Disabled
• Enabled
(default)
Enables or disables the onboard LAN device.
For boards with no onboard LAN audio subsystem, this option
will not appear; however, this option does appear if a CNR
card with a LAN subsystem is installed.
Modem Device
• Disabled
• Enabled
(default)
Enables or disables a modem device on a CNR card.
This option appears only when a CNR card with a modem is
installed.
Legacy USB Support • Disabled
• Enabled
(default)
Enables or disables Legacy USB support.