Pioneer PRV-LX10 - Manual (Page 85)

85
PRV-LX10
En
English
HDD Tools
Control Settings
Video Settings
HDD Recording
Info Language
Video/Audio
Target Drive
Remaining Capacity
Control
Port
Time Code
Eject Settings
External Sync
OSD
Composite Out
Background Color
DV OUT
Test Signal
Time Shift PLAY
Language
Video Encode Rate
Video Filter(NR)
Audio Encode
Audio Level
Aspect
Setup Level (*8)
HDD
USB HDD (*5)
xxxxGB
Local
Remote
RS-422A
Disabled
IEEE1394 (*6)
RS-422A
LTC
IEEE1394 (*6)
Eject
Finalize & Eject
Disabled
Enabled
Enabled
Disabled
Source Monitor
Decoder Out
Black
Blue
Enabled
Disabled
Start
Enabled
Disabled
English(GB)
Français
Deutsch
Español
Svenska
32 Levels Setting
16 Levels Setting
Dolby Digital
LPCM
(L) –48 to +14 setting
(R) –48 to +14 setting
(L/R) –48 to +14 setting
4:3
16:9
0 IRE
7.5 IRE
Format and confirm operation of data
area of HDD.
Display hard disk or USB HDD free
space.
Switch external control.
Select external control port.
Select time code input.
Select Eject command operation.
Select external sync signal for
playback.
Enable/disable OSD display.
Enable/disable input pass-through for
composite/RCA output.
Select background image during
idling.
Enable/disable DV connector output.
When enabled, outputs during
playback only. (*7)
Output color bar.
Enable/disable playback of previous
recorded portion during recording
(time-shift recording).
Select language for information
display and character input on
Function Menu.
Set encoding rate.
Set video filter level.
Select audio encoding format.
Set audio level.
Select video aspect ratio.
Select setup level.
SET UP System
Operation
Recording
Function Menu Table
*5: Displayed only when USB HDD is connected.
*6: Displayed only when [V Input] is set to “DV”.
*7: Playback begins about 5 seconds after pressing the PLAY button on front panel/remote
control unit.
*8: Not displayed when TV system is set to PAL.