Pioneer PRV-LX10 - Manual (Page 21)

21
PRV-LX10
En
English
PLAY
PAUSE DISPLAY REPEAT
AUDIO SCAN
STEP RPT A-B
ANGLE SUBTITLE PREV NEXT
SETUP
ENTER
RETURN
SEARCH CLEAR
1 2 3
4 5 6
7 8 9
0 10 >
TITLE/CHP
FRM/TIME
MENU
SETUP TOP
MENU
FRM/TIME
STOP
DXX2527
2 Press the remote control unit’s SETUP button
3 Using the mouse to display and access the
playback control bar.
Press both right and
left mouse buttons
simultaneously.
Control bar is displayed.
\
Press the FUNCTION button
Move the mouse cursor
over the FUNCTION
button and click the
mouse’s left button.
4 Access from the Keyboard by Assigning a
Function key.
Use main unit setting to assign
FUNCTION button to F1 key.
Function Menu
appears when F1
key is pressed.
7 To Exit the Function Menu
Use either of the following methods:
1 Press the Exit button found on any of the sub-
menus (move mouse cursor over the Exit button
and press the left mouse button).
2 Press the main unit’s front panel FUNCTION
button.
3 Press the remote control unit’s SETUP button.
4 Click the right button on the mouse
(Note 6) .
5 If the Function Menu has been assigned to a
function key on the keyboard, press that key.
Note 6:
Use of the mouse’s right button to exit the Function Menu
is supported only during display of the top menu.
7 Control Bar
The control bar is displayed by pressing the mouse’s
right and left buttons simultaneously. When the
control bar is displayed, pressing the mouse’s right
and left buttons once again will cause the control bar
to be hidden. When the mouse cursor is moved over
the control bar, the cursor pointer arrow changes
to a hand
. When the hand is displayed, it can
be used to perform the same operations available
with the remote control unit; move the hand over the
desired item and select by clicking the left mouse
button.
The position of the control bar can be changed by
placing the mouse cursor on the left edge and
dragging.
(Note 7)
Note 7:
The movable range of the control bar is limited to that area
not overlapping the OSD display. Also, the new location of
the control bar is preserved until the Function Menu is
displayed.
Basic PRV-LX10 Operations
Control bar