beautypg.com

Pride Mobility Jet 10 User Manual

Page 35

background image

Jet 10/Rev H/Feb03

www.pridemobility.com

35

X . C A R E A N D M A I N T E N A N C E

n If the battery condition meter is blinking rapidly, the controller has detected a fault in either its own circuits or in

your Jet 10’s circuits. See VIII. “Operation.”

n Use a rubber conditioner on the tire sidewalls to help preserve them. Check for wear.

WARNING! Never use a rubber conditioner on the tread area of the tires; doing so may make the

tires slippery and cause your power chair to skid.

n The body shroud has been sprayed with a clear sealant coating. You can apply a light coat of car wax to help

it retain its high-gloss appearance.

n Check all electrical connections. Make sure they are tight and are not corroded. Batteries must sit flat within

the battery well, with the battery terminals facing inward, toward each other. Refer to the frame decal for the

correct wiring layout.

n All wheel bearings are prelubricated and sealed. They require no subsequent lubrication.

DAILY CHECKS

n With the controller turned off, check the joystick. Make sure it is not bent or damaged and that it returns to

center when you release it. Check the rubber boot around the base of the joystick for damage. Visually inspect

the boot. Do not handle or try to repair it. See your authorized Pride provider if there is a problem.

n Visually inspect the controller harnesses. Make sure that they are not frayed or cut or have any wires

exposed. See your authorized Pride provider if there is a problem with any of these harnesses.

WEEKLY CHECKS

n Disconnect and inspect the controller and the charger harnesses from the utility tray. Look for corrosion.

Contact your authorized Pride provider if necessary.

n Ensure that all parts of the controller system are securely fastened to your Jet 10. Do not overtighten any

screws.

n Calibrate the joystick if a noticeable difference in performance is detected or if the joystick does not operate

properly. To calibrate the joystick, power off the unit, place the joystick in neutral position, and power the unit

back on. If a problem still exists with your joystick’s performance, contact your authorized Pride provider.

n Check the brakes. This test should be carried out on a level surface with at least three feet of clearance around

your Jet 10.

To check the brakes:

1. Turn on the controller and turn down the speed and response adjustment knob.

2. After one second, check the battery condition meter. Make sure that it remains on.

3. Slowly push the joystick forward until you hear the electric brakes click. Immediately release the joystick. You

must be able to hear each electrical brake operating within a few seconds of joystick movement. Repeat this

test three times, pushing the joystick backward, then left, and then right.