Pride Mobility Jet 10 - Manual (Page 22)

22 www.pridemobility.com Jet 10/Rev H/Feb03
V I . C O M F O R T A D J U S T M E N T S
After you have become familiar with your Jet 10’s opera-
tion, you may find the need to adjust the seat. There are
some adjustments you can make to increase your com-
fort such as seat height, armrest width, height and angle,
footrest height and angle, and joystick position.
WARNING! If your power chair was con-
figured at your authorized Pride provider,
please consult your healthcare profes-
sional before changing the seat position
or making any other adjustment. Some
adjustments may degrade your Jet 10’s
performance and safety by changing its
center of gravity.
SEAT HEIGHT
You can change the seat height manually.
To change the seat height:
1. Remove the seat. See VII. “Disassembly.”
2. Use a 7/16-in. socket or wrench to remove the nut and
bolt from the seat post. See figure 12.
3. Raise or lower the seat post to the desired position.
4. Install the nut and bolt into the seat post.
5. Install the seat.
Figure 12. Seat Post Nut And Bolt
NUT AND BOLT
Figure 13. Armrest Width and Height
LOOSEN SETSCREWS TO CHANGE ARMREST HEIGHT
ARMREST WIDTH
To change the armrest width:
1. Locate the two setscrews on the armrest receiver bracket. See figure 13.
2. Loosen the setscrews, slide the armrests in or out for the desired width.
3. Tighten the setscrews.
LOOSEN THUMBSCREWS TO CHANGE ARMREST WIDTH