Polaris 600 RMK - Manual (Page 94)

2
1
3
91
MAINTENANCE
General Maintenance
Removing Halogen Bulbs
NOTE: Do not touch a halogen bulb with bare fingers. Oil from skin
leaves a residue, causing a hot spot that will shorten the life
of the lamp. If fingers do touch the bulb, clean it with an
alcohol-moistened towel.
1. Remove the plenum covering
from the headlight assembly.
2. Lift the rubber boot to expose
the bulb.
3. Push down on the spring (1)
to release it from the housing.
4. With the wire harness (2) attached
to the bulb (3), withdraw the bulb from the housing.
5. Grasp the bulb by its metal base and carefully separate the bulb
from the harness.
Installing Halogen Bulbs
1. Hold the bulb by its metal base and install it into the wire harness.
2. Insert the bulb into the housing.
3. Connect the spring to the housing.
4. Carefully flip the spring back into the housing, placing it around
the wire harness.
5. Reinstall the plenum covering on the headlight assembly.
6. Verify headlight aim.
Replacing Taillight Bulbs
1. Remove the screws securing the taillight lens.
2. Push the bulb in and twist counterclockwise and replace the bulb.
3. Replace the taillight lens.