Patton electronic 1092A - Manual (Page 4)

7622 Rickenbacker Dr., Gaithersburg, MD 20879
Phone: (301) 975-1000 • Fax: (301) 869-9293 • E-mail: [email protected] • WWW: http://www.patton.com
The Ethernet Bridge Module is a likely
solution for connecting LANs over fiber
or copper in a campus. It can also be
used to connect LANs between remote
branches or satellite offices and the head
office. In wide area networks, the
Ethernet Bridge Module connects LANs
across distances up to 18.2km at speeds
up to 2.048Mbps.
The screw-in QuikConnect package
allows the Ethernet Bridge Module to be
installed into the rear panel of any Patton
transmission product with two thumb-
screws. No tools are necessary. Dual
LEDs monitor the Ethernet link and CPU
status. Scalable onboard RAM allows
the Ethernet Bridge Module to buffer up
to 4,000 frames.
Up to 4,096 MAC addresses are dynami-
cally learned by the Ethernet Bridge
Module and addresses age out of the
table after a period of inactivity.
A
PPLICATIONS
Cash Register
ATM
Machine
Ethernet
Hub
2W/4W/MMF
circuit Patton Modem
Patton Modem
Point Of Sale
Terminal
10BaseT
VSAT Station
Ethernet Bridge
LAN Interface 10BaseT to 802.3 Ethernet via RJ45 connector
LAN Address Table 4,096 MAC addresses
Frame Latency 1 frame
Frame Buffer 512 frames (standard), upgradeable to 4,000 frames
WAN throughput Up to 2Mbps dependent on transmission product
Address Aging 1-20 minutes (factory configured)
Approvals FCC Patt 15, Class A; CE Mark per EEC Directive
89/336/EEC and Low Voltage Directive 73/23/EEC
Dimensions 2.9" x 3.2" (7.36 x 8.12 cm)
Ethernet Bridge Module Specifications
Ethernet Bridge Module