Philips DCR 9001/22 - Manual (Page 40)

87
EN
15 Programming your remote control for your
audio/video equipment brands
Prior to using your universal remote control, check or set the following:
- Device you want to control (Mode selection)
- Volume and mute control assignment
- Brand setting for your TV,VCR, DVD and Amplifier
15.1 Mode selection (selecting the device you want to control)
Your 5-in-1 remote control can be used to control most of your audio/video equipment
through various modes:
- STB mode for the control of your Digital Receiver
- TV mode for the control of your TV set
- VCR mode for the control of your VCR
- DVD mode for the control of your DVD or DVD Recorder
- AMP mode for the control of your audio tuner/amplifier.
Press SELECT once to check which mode is active.To change the mode, press SELECT repeatedly until the desired mode is
signalled by the corresponding indicator.The mode sequence is STB --> TV --> VCR --> DVD --> AMP.
15.2 Volume and mute control assignment
15.2.1 Default volume and mute control assignment
For each mode, you can select the device of your audio/video set-up to which volume and mute control is
assigned.
When in STB mode, the volume functions (
+, - and keys) can be controlled through your TV set,
amplifier, or digital receiver. By default, volume control is performed through a Philips brand TV set.
When in TV, VCR or DVD mode, the volume functions ( +, - and keys) can be controlled
through your TV set or amplifier. By default, volume control is performed through a Philips brand TV set.
When in AMP mode, the volume functions ( +, - and keys) can be controlled through a Philips brand amplifier only.
15.2.2 Changing the volume and mute control assignment
The procedures below assume you start from default settings.
Your Digital Receiver (STB),TV,VCR or DVD audio outputs are “all” connected to your amplifier
We advise you to assign volume control to your amplifier for all modes (STB,TV,VCR, and DVD).To do so:
- Press SELECT repeatedly to select the AMP mode.
- Simultaneously press keys 1 and 3 until the AMP indicator turns on then release these keys.
- Enter code 993.The indicator surrounding the
key blinks once after each entry.
- Press the key.The indicator surrounding the key blinks twice.
From then on, whatever mode you are in, the AMP indicator turns on each time you press one of the ( +, - and keys).
When controlling the volume, make sure the source selector of your amplifier is properly set (refer to your amplifier user manual
for source selection).
Your TV set is only fitted with SCART connectors (no HDMI, no DVI and no YPbPr)
We advise you to assign volume control to your digital receiver for the STB mode.To do so:
-
Press SELECT repeatedly to select the STB mode.
- Simultaneously press keys 1 and 3 until the STB indicator turns on then release the keys.
- Enter code 993.The indicator surrounding the key blinks once after each digit entry.
- Press the - key.The indicator surrounding the key blinks twice.