Philips DCR 9001/22 - Manual (Page 29)

77
EN
12.4 Scan
This screen is used to view the date and results of the last scan performed. It may
also be used to launch a new scan.
- Press the green colour key to scan the KDG network.
- Alternatively, press the yellow colour key to search for All channels.
12.5 Display
This screen is used to set your receiver according to your TV set screen format and
depending on the output selected (HDMI/DVI,YPbPr, or EXT1/2).
- Set values for the following (default settings are underlined):
- Press EXIT to exit the screen.
12.6 Dolby Digital out of the digital audio
output
This screen is used to enable/disable Dolby Digital sound.
When Dolby Digital is disabled, you can still get stereo sound in digital format (PCM).
12.7 Wake up
This screen is used to set the channel to be tuned at the receiver wake-up. Default
setting is programme 100.
HDTV output SDTV output
HDMI/DVI YPbPr EXT1/2
TV Screen Format 16: 9
4: 3 or 16: 9, depending
on your TV set
Display format
Full Screen or Pillar Box, or Extended
See table in paragraph 13.5.1.
Auto or Letter Box, or
Centre Cut-Out
Resolution Auto, 1080i, 720p, or 576p
Not adjustable
(always 576i)
TV SCART Output
Not applicable
RGB (recommended) or
CVBS , or S-VIDEO
AV Control
On (recommended) or
Off