12 premiere menu, 1 pin code change, 2 smartcard – Philips DCR 9001/22 User Manual
Page 28: 3 system
76
EN
The Premiere Menu includes the following items:
o PIN Code Change
o Smartcard
o System
o Scan
o Display
o Dolby Digital
o Wake up
12.1 PIN Code Change
This screen is used to modify the PIN code for the protection of minors.
To modify your PIN-Code, follow the instructions displayed on screen.
12.2 Smartcard
This screen is used to display information about your smartcard.
12.3 System
This screen is used to display information about your receiver, including the Premiere
Serial Number and software version.
12.3.1 Software Upgrade
12.3.1.1 Automatic software upgrade notification
While in Stand-by, your receiver searches for software upgrade. If available, a
notification is displayed at receiver wake-up from Stand-by.To upgrade your receiver,
follow the instructions displayed on screen.
12.3.1.2 Check for new software availability
- Press the red colour key from the System screen described above to launch a
search for new software. After a few seconds, the Software Upgrade screen
indicates whether new software is available.
- To proceed with the receiver software upgrade, refer to paragraph 13.5.5.2.
12.3.2 Factory Settings
This screen is used to reset your receiver back to the factory default condition.
- Press the green colour key.
- When prompted, press the green colour key again to confirm.
- Alternatively, press EXIT to exit the screen without modifying the receiver settings.
If you reset your receiver to factory settings, you lose all the settings you stored
previously.
12 Premiere Menu