Philips DCR 9001/22 - Manual (Page 20)

68
EN
You have inserted the batteries supplied in your remote control.
Your receiver is connected to the cable wall socket,TV set and other equipment
according to one of the diagrams in chapter 7.
- Switch on your TV set and select the appropriate HDMI input (refer to your TV
set user manual).
- Plug the receiver’s power supply cord into the mains.The receiver display indicates
, then .
- Press V-Output once, then check the receiver display indication:
• If is displayed, check that the welcome screen
displays on your TV screen.
• if is displayed instead, successively press V-Output
until the source selected matches your connections as described in
paragraph 7.1 and the welcome screen appears on your TV screen.
- Press P+ then P-.Wait for a few seconds for the First Installation screen to
appear.
8.1 Installation settings
- Select your favourite language.
- Check for adequate signal strength and quality.
- Press OK to start searching for channels.The Installation screen appears.
- Proceed to paragraph 8.2.
If you press EXIT during the scanning process, you interrupt the scanning and
go back to the previous screen. In this case, none of the channels found are stored.
8.2 Channel search
Once the scan has been successfully completed, a completion message is displayed.
- Press OK.
A new screen appears, with a message indicating that a search for new, upgraded
software is in progress:
- Either wait for software detection, and then proceed as indicating on screen. It is
recommanded to accept software so as to keep your receiver up-to-date.At the end
of the first installation, the receiver tunes to the first channel in the main TV list.
- Or press EXIT to stop searching for new software and tune the receiver to the
first channel in the main TV list.
8.3 Search failure
In case of channel search failure, a message is displayed.
- Press EXIT to go back to the First Installation screen.
Before starting a new scan
The following checks are recommended to recover adequate signal quality and
strength:
• Check the RF coaxial cable.
• Then check the RF coaxial cable connection to your receiver (see chapter 7).
- When the signal strength and quality is adequate, press OK to launch a new
search.
If the failure message appears again, refer to chapter 17 to find out the reason for failure.
For a proper diagnosis and installation check, call your installer.
8 First installation