Philips VR 969/02 - Manual (Page 43)

43
ENGLISH
Playback via the aerial cable
If you do not wish to use a Scart cable, you must use
the already connected aerial cable for playback from
the video recorder.
! Switch on the TV set and select the programme
position intended for the video recorder (see the
operating instructions of your TV set).
"
Press the buttons V and G (Playback) on the
video recorder simultaneously.
A test picture emitted by the video recorder
appears on the picture screen.
“MODULATOR” appears in the video recorder
display with a channel number and frequency.
¤ You must enter and save this channel number or
frequency on your TV set.
How to proceed on the TV set to enter the channel
number or frequency is described in its operating
instructions.
The video recorder transmits a test picture which
appears on the picture screen of the TV set.
Information: your video recorder occupies UHF channel
36. However, it is possible that in your reception area
this channel is already occupied by another TV station.
In this case, the picture quality of one or more TV sta-
tions on the TV may be reduced.
Note:
* When later playing back from the video recorder,
check the picture and sound quality on the picture
screen of the TV set. If necessary, finetune the
picture, colour and sound by re-adjusting the chan-
nel on the TV set.
If this should be the case, proceed as follows:
$
Check whether all TV channels function exactly as
they did before.
If the picture quality of one or more TV channels
has disimproved, switch off the video recorder for
checking purposes. Check all the TV set’s channels
again.
% If picture interference only occurs when the video
recorder is switched on, you must search for a
'free' video recorder channel.
&
Press the video recorder buttons V and G
(Playback) simultaneously.
/ Press the video recorder button S. The
video recorder searches for a 'free' channel. The
message 'MODULATOR' and e.g. 'C44' or '655'
appears on the video recorder display.
(
Reset the TV to the video recorder (Step
¤
).
Store the setting by pressing the button B.
)
If the result is unsatisfactory, you can also enter
the channel number or frequency manually.
<:
Search for a free channel on your TV set (screen
only flickers).
<>
Press the video recorder buttons V and G
(Playback) simultaneously.
Using the buttons f or e or the digit buttons
k, enter the 'new' channel number or frequen-
cy of your TV set. You will see the test picture.
Store the setting by pressing the button B.
Check all channels on the TV set again. Repeat the
setting (steps
<:
and
<>
) until such time as you can
no longer detect a difference in the picture
between when the video recorder is switched on
and when it is off.
Switch off the video recorder by pressing the
button d.
Note:
* If you interrupted the setting described in Chapter
2 'INSTALLATION', continue with initial installation.