Panasonic AJ-SD930BE - Manual (Page 30)

30 (E)
CONTENTS
Setup menus
1
Press the MENU button.
2
When the FF button is pressed while holding down
the DIAG button, the next user file is selected;
conversely, when the REW button is pressed while
holding down the DIAG button, the previous user
file is selected.
3
To enter the selection made in step
2
for the user
file which is to be used, press the SET button.
The user file is changed and stored in the memory.
This VTR can hold five user files, each of which has
its own specific menu settings, and one of these files
can be selected for use.
Changing the file
1
Press the MENU button.
2
Press the REW button or FF button while holding
down the DIAG button to select the file for which
the lock mode is to be set or released.
3
Turn the search dial to move the cursor (2) on the
menu screen to No. 30 (MENU LOCK) for the
system file or to No. A03 (MENU LOCK) for a user
file.
4
Turn the search dial while holding down the search
button to select whether the lock mode is to be set
or released.
To set the lock mode:
Set 0001 (ON) as the setting.
To release the lock mode:
Set 0000 (OFF) as the setting.
When the lock mode has been set, “LOCKED”
flashes on the menu screen. The counter display
stops flashing and remains lit.
5
Press the SET button.
The setting is stored in the memory.
The lock mode can be set to protect the system file
and user file (USER2 to USER5) settings. Once the
lock mode is set, no further changes can be made to
the settings.
Setting and releasing the lock mode can be set for the
system file by using setup menu No. 30 (MENU
LOCK) and for the user files by using setup menu No.
A03 (MENU LOCK).
Setting and releasing the lock mode
SYSTEM
FF REW
USER 1
FF REW
USER 2
FF REW
USER 3
FF REW
USER 4
FF REW
USER 5
FF REW
User files
Each user file contains the
following items.
O BASIC
O
OPERATION
O
INTERFACE
O EDIT
O
TAPE PROTECT
O
TIME CODE
O VIDEO
O AUDIO
O
V BLANK
O
MENU
Since the SYSTEM menu items are not included in
user files 1 through 5, first select the user file and
switch to the SYSTEM file, and then set the SYSTEM
menu items.
O
The lock mode cannot be set for the USER1 file.
O Once set to the lock mode, a file cannot be reset to
the factory settings even by pressing the RESET
button.
SETUP-MENU LOCKED
NO.000-0005
2
000 P-ROLL TIME 5s
001 LOCAL ENA ST&EJ
002 TAPE TIMER ±12h
003 REMAIN SEL OFF
004 SETUP NUMBER OFF
005 METER SELECT CUE
006 SYNCHRONIZE ON
007 SUPER ON
008 DISPLAY SEL T&STA