Planet Technology ISDN Internet Telephony PBX System IPX-1800N - Manual (Page 51)

PLANET IP PBX user’s manual
1. Enter settings shown in Table 5.4.
2. Click APPLY.
Table 5.4 Voice Mail Configuration Settings
Field Description
Voicemail Pilot Number Number to access voice mail system IVR.
Minimum Message Time
Messages less than this duration will not be notified by e-
mail. E.g., 3 (sec).
Maximum Message Time
Maximum duration allowed for a single message. E.g., 60
(sec).
Maximum number of messages per
account
Maximum number of messages allowed per extension.
SMTP Server
Hostname or IP address of the SMTP server for voicemail
notification.
E-mail from Address
Most SMTP servers require a valid from address to accept
a mailing request.
Voicemail Available Space Check Select to enable the Alarm Email function described below.
Send Alarm Email when Space
Below
Set a threshold in minutes to send an alarm email to the
administrator when the space left is below it.
Voicemail Space Left
Show the available space in Kbytes and minutes.
) The storage inside IP PBX saves not only voice mails but
also some other stuff, such as CDR and logs. The
remained disk space is all for voice mails, and it is the
“maximum” available voice mail space.
SMTP Server Account
Specify an account ID if the SMTP server requires
authentication for outgoing mails.
SMTP Server Password
Specify the account password if the SMTP server requires
authentication for outgoing mails.
5.5 Meet-me Prompts
This page allows replacing built-in meet-me conference prompts with user recordings.
1. Click a language and a prompt in the corresponding lists.
2. Find a corresponding recording in the local storage.
3. Click PUT FILE to complete the replacement.
4. To reset a prompt back to default, leave the Upload box in blank and directly click the PUT FILE.
Note that the replacement is done for the selected Language and Prompt only. Currently only
following prompts could be replaced.