Planet Technology ISDN Internet Telephony PBX System IPX-1800N - Manual (Page 10)

PLANET IP PBX user’s manual
2.3 On-board WAN Setup
The On-board WAN Setup page allows administrator to configure WAN network interface for PLANET
IP PBX. Select System -> On-board WAN Setup, and the current setting of WAN network interface
is displayed, e.g. type, IP address etc. Unless the “LAN Only” is selected, you can choose one of the
three options, Static IP, DHCP, and PPPoE from the Type list for your configuration. Select LAN
Only check box to disable WAN and only default router and DNS settings are applicable.
Static IP
You can click Static IP in the Type list, and manually configure the
following information:
․ IP Address
․ Netmask
․ Default gateway IP address
․ Primary, secondary or third DNS servers
Click “APPLY” to submit.
DHCP
Simply click DHCP in the Type list, and click APPLY. The acquired
IP address, netmask, and default gateway information will show
when revisit this page later.
PPPoE
1. Click PPPoE in the Type list.
2. Enter a user name and its password in User Name and
Password boxes.
3. Click “APPLY” to submit.
The PPPoE dialing will start right away. When there is an active
connection, the page will show the acquired IP address, network
mask, and default gateway information.
LAN Only
Select LAN Only to disable WAN IP settings but allow the
configuration of default gateway and primary/secondary/third DNS
servers.