Precor Low Impact M9.33 - Manual (Page 62)

M9.3x Low-Impact Treadmills Assembly Guide 4
Assembly Steps
Use a ¼-inch hex key and ½-inch
box end wrench to remove the
four shipping fasteners on the
front panel. Discard the fasteners.
Unwrap the cable and feed it through
the right side upright. Tape the cable
to the top.
Place the right side upright into the base
frame side bracket. Secure the upright to
the front panel using two socket head
screws (C). Secure the upright to the
side bracket using two socket head
screws (A), two washers (D), and two
barrel spacers (B). Finger tighten.
Important: Do not stretch, crimp, or
damage the cable. Cables damaged by
improper installation will not be covered
by the Precor Limited Warranty.
Place the left side upright into the base
frame side bracket. Secure the upright
to the front panel using two socket
head screws (C). Secure the upright to
the side bracket using two socket head
screws (A), two washers (D), and two
barrel spacers (B). Finger tighten.
Attach the display console using
four socket head screws (G)
and four washers (D). Finger
tighten.
Hold the cable while you remove
the tape. Connect the cable to
its receptacle. Slide the cable
into the clip on the underside of
the display console.