Panasonic VB-43320 - Manual (Page 31)

Release Notes Panasonic@
CPC-EX, Version 1 .O (Preliminary) June
Additional Serial Port on CPC Card
Description
The CPC-EX card contains an on-board serial
port
(Serial Port 2) which can be
used for Bus Monitor/ Remote Maintenance. This serial port (labeled CN5) is
located just above the
on the front of the card (see the illustration on page 8).
This additional serial port allows you to dial directly into the system for remote
maintenance, without having to disconnect the SMDR cabling the backplane
serial port (Serial Port 1).
l
Serial Port 1 (the backplane port) and Serial Port 2 have separate controls for
baud rate, stop bit, parity, and data length
Installation
Serial Port 2 requires the CPC-EX Serial Port Adapter Cable (VB-43890). This
cable connects to Serial Port 2 via a
connector, and to a programming
terminal via a DB25 connector.
Figure 14. CPC-EX Port 2
Master Cabinet
I
Serial Port Adaoter Cable End
(Requires Male)
Terminal End
(Requires or Male)
Pin No. and Connection
I In
1
I I
CD
7 4
I 5 I CTS
I
I
l The standard DBS cable (normally connected to may be
to the programming terminal.
Page 32
l
Additional Serial Port on CPC Card
Technical Manuals Online! - http://www.tech-man.com