Panasonic WV-CP504 - Manual (Page 27)

27
Back focus setting [BACK-FOCUS SETUP]
Selects the back focus setting type and performs fine adjustment. The following setting can be configured on the "BACK-
FOCUS SETUP" screen displayed from the top screen. Refer to page 5 for how to call up the screen.
The lens adjustment (☞ Installation Guide) shall be performed before the back focus adjustment.
The back focus adjustment is performed by changing the distance between the lens and focal point.
Follow the procedure below.
Important:
• The auto back focus function is used for back focus adjustment at installation and for focus correction at switching between
the color and black-and-white modes after installation. This function is not a function that is supposed to be operated contin-
uously such as the auto focus function.
• When focus missing occurs due to secular change in the lens and installation environment or peripheral temperature
change, the back focus adjustment is required again.
Note:
• The back focus adjustment can be also performed through the operation buttons. (+ Installation Guide.)
Step 1
Move the cursor to "PUSH SW" of "ABF" and press the setting button.
→ The auto back focus function provides back focus adjustment to automatically focus on a subject located in the center of the
screen.
Step 2
To fine adjust the back focus, move the cursor to "MANUAL-ADJ", press the setting button, and use the right or left button to
adjust the back focus manually.
Note:
• Pressing the right and left buttons simultaneously for more than 2 seconds resets the back focus position to the CS mount
default position.
• The value of "INDICATOR" is a guide to adjust the back focus. The larger the value is, the sharper the image becomes.
"BACK-FOCUS SETUP" screen
**BACK-FOCUS SETUP**
ABF PUSH SW
MANUAL-ADJ
C/L B/W AUTO
SETUP-SW LOCK OFF
NEAR FAR
......... |.........
INDICATOR XXXX FOCUSING
RET TOP END