Panasonic WV-CP504 - Manual (Page 17)

17
Detect motion of objects
Move the cursor to "MOTION" and select from the following.
ON: Provides an alarm signal when motion is detected.
OFF (default): Does not detect motion.
Detect objects that move continuously within a specified period
Move the cursor to "LOITERING" and select the duration from the following:
When a continuously moving object is detected within a specified period, an alarm signal is issued.
OFF (default)/ON (5 s)/ON (10 s)/ON (20 s)/ON (30 s)/ON (40 s)/ON (50 s)/ON (1 min)
Detect objects that move into the specified direction
Move the cursor to "DIRECTION" and select the direction from the following:
An alarm signal will be sent out when an object moves to the specified direction.
OFF (default)/ON (c)/ON (c )/ON (a)/ON (
a
)/ON (d)/ON (d )/ON ([)/ON ([ )
Step 4
Move the cursor to "AREA" and select an area for which the motion detection is to be set. All the alarm actions selected in step 3
will be applied to this area.
ALL (default): All areas will be set as the detection area.
SETUP: When the setting button is pressed after selecting "SETUP", up to 2 areas can be set as the detection area. Refer to
pages 20 for how to configure the settings.
Step 5
Move the cursor to "SENSITIVITY" and press the setting button.
→ The "SENSITIVITY" screen appears.
Step 6
Set the detection sensitivity and the minimum size of objects detected. Perform the setup while viewing the detection result dis-
played on the screen.
Set the detection sensitivity
Move the cursor to "SENSITIVITY" and select one of the following options for the detection sensitivity:
LOW (default)/MID/HIGH
Set the minimum size of objects detected
Move the cursor to "MIN SIZE" and select the minimum size of objects detected from the following: The size options will be dis-
played in a green frame in the center of the screen. In "OFF" position, any object will be detected regardless of its size.
Perform the setup while viewing the detection result displayed on the screen.
OFF (default)/SMALL/MEDIUM/LARGE
Note:
• The detection sensitivity and minimum size selected in this step will be applied to all the alarm actions selected in step 3.
• The detection areas set in step 4 will be displayed as a white frame on the "SENSITIVITY" screen.
• When a motion is detected, a blue frame appears and changes to a red frame after a given time (approx. 1 sec.) on the
"SENSITIVITY" screen. In operation, an alarm signal is provided when the frame changes to red.