Checking the alignment of the running belt – Precor C934 User Manual
Page 22
page 22
C
O
M
M
E
R
C
I
A
L
P
R
O
D
U
C
T
S
D
I
V
I
S
I
O
N
CHECKING THE ALIGNMENT OF THE RUNNING BELT
The belt is aligned at the factory before shipment. However, during shipment or
by using the treadmill on an uneven surface, the belt might move off center.
Proper belt alignment is important because it allows the belt to remain centered
and assures smooth operation.
Follow these steps to check the alignment:
1.
The treadmill has adjustable rear feet. Check to make sure that the running
surface is level (refer to steps 19 and 20 on page 20).
2.
Locate the I/O switch at the front of the treadmill and turn the unit ON.
3.
Stand beside the treadmill and press QUICKSTART. The running belt starts
automatically after the message, “
Belt Starting 3, 2, 1,...” appears.
4.
Continue standing next to the treadmill and hold down the Speed
▲ key
until the display shows a speed of 3 miles per hour (5 kph).
5.
Walk around to the rear of the unit and observe the belt for a few minutes as
it moves.
If the running belt,...
Then,...
tracks centered on the
the belt is functioning correctly. It is
running surface
evenly distributed between the side rails
so no adjustment is necessary.
runs or drifts off center
you need to adjust the belt; see
Aligning the Running Belt, page 47.
Important: If you notice that the belt needs alignment, make the adjust-
ments at once. Failure to do so might cause the belt to tear or fray which is
not covered by the Precor limited warranty.
6.
To stop the running belt, press the red Stop button.
If the belt is functioning correctly, the treadmill is ready to use. Please continue
on to
Club Information to learn how to customize the treadmill for your Club.