Philips MCM8 - Manual (Page 19)

19
3139 115 23001
English
IMPORTANT!
Make sure the FM and AM antennas are
connected.
Tuning to radio stations
1
Press TUNER to enter tuner mode.
To select another waveband (FM or AM,)
press TUNER again.
2
Press and hold à or á until the frequency
indication starts to change, then release.
➜ The system automatically tunes to the next
strong signal radio reception.
➜ lights up for FM stereo reception.
For tuning to a weak signal station
● Press à or á briefly and repeatedly until an
optimal reception is found.
Presetting radio stations
You can store up to 40 preset radio stations in
the memory, starting from FM and followed by
AM bands.
Helpful Hints:
– The system will exit presetting mode if no button
is pressed within 20 seconds.
– If no stereo frequency is detected during Plug
and Play, "
CHECK ANTENNA" appears.
Tuner Operations
Using the Plug and Play
Plug and Play allows you to store all available
radio stations automatically.
M I C R O S Y S T E M
IR
1
Connect the system to the power supply,
"
AUTO INSTALL – PRESS PLAY" appears.
OR
In Eco Power standby / standby mode ,
press and hold ÉÅ on the main unit until
" AUTO INSTALL – PRESS PLAY" appears.
2
Press ÉÅ on the main unit to start
installation.
➜ " INSTALL TUNER AUTO" appears.
➜ All previously stored radio stations will be
replaced.
➜ Once completed, the last tuned radio station
will play.
001-027-MCM78_37-Eng 4/8/04, 15:01 19