Philips MCM8 - Manual (Page 18)

18
3139 115 23001
English Programming the disc tracks
Programming tracks is possible when playback is
stopped. Up to 99 tracks can be stored in the
memory in any order.
2
4
6
7
3 5 ,
1
MP3-CD / CD-R / CD-RW COMPATIBLE
M I C R O S Y S T E M
IR
CLOCK RDS/ NEWS STANDBY-ON
ECO POWER OPEN/ CLOSE
MP3-CD / CD-R / CD-RW COMPATIBLE
CD
PROGRAM
1
Load the desired disc on the disc tray (refer
to “Loading disc”.)
2
Press CD to select a disc.
3
Press PROGRAM to start programming.
➜
PROG
starts flashing.
4
Press í or ë repeatedly to select the
desired track.
● For MP3 disc, press а / б and н / л to
select the desired album and title for
programming.
5
Press PROGRAM to store.
● Repeat steps 4~5 to select other tracks.
➜ If you attempt to program more than 99
tracks, " PROGRAM FULL" appears.
6
To start program play, press ÉÅ.
7
To stop playback or to end the programming,
press
Ç once.
➜
PROG
stays and the program mode remains
active.
Helpful Hints:
– If the total playing time reached 100 minutes or
if one of the programmed tracks has a number
greater than 30, then "
-- : --" will appear instead
of the total playing time.
– The system will exit programming mode if no
button is pressed within 20 seconds.
Checking the program
1
Stop playback and press í or ë repeatedly.
2
Press ÉÅ to start playback from the
current programmed track.
Clearing the program
● Stop playback, then press Ç to clear the
program.
OR
Press the OPEN/ CLOSE
0 button of the
disc tray.
➜
PROG
disappears from the display and
" PROGRAM CLEARED" appears.
Helpful Hint:
– If the system is disconnected from the power
supply or you switch to other source mode, the
program will be erased.
Disc Operations
001-027-MCM78_37-Eng 4/8/04, 15:01 18