Philips TTX400 - Manual (Page 63)

Philips indoor luminaires 8.62 Light-line systems
TTX400
TTX400 Linesense
TTX400 with Lighting Controls
Applying Lighting Controls in industry contributes to efficient and
effective lighting solutions. For TTX400 applications, Philips Lighting
offers various standard trunking system based controls solutions,
included in the Linesense range. These solutions offer an intelligent
light-line, which remains easy-to-install.
With Linesense, TTX400 and lighting controls are combined in one,
creating an intelligent light-line which is still easy to install. It allows
substantial energy savings of up to 75%. Developed for industrial
applications like warehouses,
Linesense consists of a 618 mm section of trunking, which is fully pre-
equipped and wired for addition to the trunking. The control function
is integrated into this extra unit and can easily be clicked between
the light-line and the electrical connection unit. Movement detectors
are connected with standard RJ-12 cables and mounted at the right
location with the use of dedicated brackets. Linesense is equipped as
standard with a telejack splitter to easily connect the detectors to the
light-line.
Fully assembled TTX400 Linesense unit
ZTX400 MDU-D Linesense unit
suitable for movement detection
(dimming or switching off), daylight
linking and manual control; works with
HFR DALI ballasts The ZTX400 MB-MDU is a Linesense
mounting bracket for clicking
movement detector LRM 8115/00 or
LRM 8117/00 to the trunking section.
The right tilt angle can be adjusted
manually and is to be checked by a walk
test. The same tilt angle can be easily
reproduced on more sensors thanks to
a click graduation on the bracket
Light sensor intended for high-bay
mounting (approx. 7.5 m high).
Intended for use with the Linesense
control (ZTX400 MDU-D). An
installation bracket is included. The
sensor is connected to the control
unit with a modular plug-in (RJ-12)
connector cable High-bay passive infrared movement
detector (mounting height up to
15 m), equipped with an adjustable
delay timer (up to 35 minutes). Can
be used with all MDU control units. A
dedicated mounting bracket (ZTX400
MB-MDU) is available, into which the
movement detector can be clicked
Accessories
Indoor_2008_Chapter_08_LIS.indb 62 20-05-2008 13:26:40