Philips TTX400 - Manual (Page 26)

Philips indoor luminaires 8.25
Maxos
Light-line systems
Light-line systems
Type 4MX091
Projector adapter for Bus bar system
Suitable trunking and
projectors For trunkings with Bus bar system only, to fix
specific projectors with ceiling base plate
Length 600 mm
Material Sheet steel, white (WH) or silver (SI)
Installation Click-in fixation (mechanical and electrical) on
trunking. Most Philips projectors, versions with
ceiling base plate - can be fixed by screwing the
base plate to the projector adapter units
Main applications Retail (e.g. food, fashion)
Maxos TL-D
Extended trunking
Type 4MX056
Length 1 x or 2 x length of electrical unit 58 W (581 or
582)
Electrical circuit option Flat ribbon cable, 5 or 7 wires
Others on request
Extention length 300 and 600 mm in the middle (M), or in the
middle and at the end (ME)
Material Hot-dip galvanized steel in white (WH) or silver
(SI)
Accessory Trunking end piece and mains connection set
(9MX056 EP SET), trunking coupling pieces etc.
(see chapter Maxos accessories)
Maxos 4MX091 projector adapter Maxos 4MX056 TL-D extended
trunking section M300/E300/M600/
E600 and blind cover, used to close
the spaces in the trunking where no
electrical units are mounted; available in
white or silver
Maxos TL-D extended trunking
The extended trunking sections are made of hot-dip galvanized steel
with a white or silver finish. They are available in lengths of 1 and 2
electrical units of 58 W. Extensions of 300 and 600 mm in the middle
only (M), or in the middle and at the end of these trunking sections
(ME), allow interrupted lines where the gaps between the electrical
units correspond to the extended trunking length. The gaps can be
filled by blind covers, available as accessories.
A flat ribbon cable (5 wires) is integrated in the trunking and
guarantees (in combination with an integrated phase selection switch
and contact blocks) safe and correct cabling.
For suspended light-lines, the trunking sections are connected using
the integrated electrical connector and a sturdy external mechanical
coupling piece (accessory). Surface-mounted light-lines use the same
integrated electrical connector and an internal coupler (accessory).
On the upper part of the trunking section, special knock-out openings
enable cable entry wherever needed.
Indoor_2008_Chapter_08_LIS.indb 25 20-05-2008 13:23:12