Connecting an amplifier or system component, Ge tt in g st ar te d, Connection to a stereo amplifier – Panasonic DMR-E65 User Manual
Page 9
9
RQT7542
G
e
tt
in
g
st
ar
te
d
≥
Decoder here means the device used to decode scrambled broadcasts (Pay TV).
≥
Change the “AV2 Input” and “AV2 Connection” settings in the SETUP menu to match the connected equipment (
➡
page 44) after tuning is
completed (
Viewing video from the decoder on the television while the
unit is stopped, or while recording
If you connected the television to the AV1 terminal and the decoder
to the AV2 terminal on this unit, press [0]
i
[ENTER]. (“DVD”
appears on the unit’s display.)
Press again to cancel. (“TV” appears on the unit’s display.)
≥
If the television is compatible with RGB input, the RGB output
signal from the decoder can also be output from the main unit the
same way.
∫
To enjoy multi-channel surround sound on
DVD-Video
Connect an amplifier with Dolby Digital, DTS and MPEG decoders
using an optical digital audio cable and change the settings in
“Digital Audio Output” (
➡
page 43) after tuning is completed
≥
You cannot use DTS Digital Surround decoders not suited to DVD.
≥
Even if using this connection, output will be only 2 channels when
playing DVD-Audio.
∫
Connection to a stereo amplifier
Connecting a satellite receiver, digital receiver or decoder
P
R
RF IN
RF OUT
COMPONENT
VIDEO OUT
P
B
Y
AV1 (TV)
AV2 (DECODER/EXT)
(PROGRESSIVE/
INTERLACE)
AV OUT
Satellite receiver,
digital receiver or
decoder’s rear panel
21-pin Scart cable
This unit’s
rear panel
Connecting an amplifier or system component
R - AUDIO -
R - AUDIO -
OPTICAL
DIGITAL AUDIO OUT
(PCM/BITSTREAM)
AC IN
OPTICAL IN
Optical digital audio cable
Do not bend this cable sharply.
Insert fully, with this side facing up.
This unit’s rear panel
Amplifier’s rear panel
R - AUDIO - L
VIDEO S-VIDEO
R - AUDIO - L
VIDEO S-VIDEO
OPTICAL
OUT
AV
4
I
N
DIGITAL AUDIO OUT
(PCM/BITSTREAM)
AUDIO IN
R L
Audio cable
Red White
Red White
This unit’s rear panel
Amplifier’s rear panel
Do not place the unit on
amplifiers or equipment
that may become hot.
The heat can damage the unit.
9
E65.book 9 ページ 2004年5月12日 水曜日 午後2時53分