beautypg.com

Preparation, Clock setting, Remote control unit – Panasonic CQ-C3100U User Manual

Page 4: Subwoofer

background image

10

CQ-C3400/3300/3200/3100U

E
N

G

L

I

S
H

CQ-C3400/3300/3200/3100U

11

E
N

G

L

I

S
H

Preparation

1

2

3

Battery Installation

1

Remove the battery holder.

Pull the holder out at position B while pushing

position A as indicated.

2

Install the battery on the battery holder.

3

Insert the battery holder back into its original

position.

Battery Notes

≥ Battery type: Panasonic lithium battery (CR2025)

(included)

≥ Battery life: Approximately 6 months under

normal use (at room temperature)

≥ Remove and dispose of an old battery

immediately.

≥ Do not disassemble or short the battery. Do not

throw a battery into a fi re.

≥ Keep the battery away from children to avoid the

risk of accidents.

≥ Follow local regulations when disposing of the

battery.

Back side

Lithium battery
(included)

Battery holder

Position A

Position B

Remote Control Unit

Caution:
≥ Improper use of the battery may cause

overheating, an explosion or ignition, resulting
in injury or a fi re.

Subwoofer

Preparation:
≥ Connect the subwoofer (option). (page 56)

Subwoofer level setting:
≥ You can change the subwoofer level. (page 34)

Subwoofer low pass fi lter setting:
≥ You can select the upper limit frequency of the

sound from subwoofer. (page 34)

CQ-C3400U

CQ-C3200U

CQ-C3400U

The 12-hour system is used for the clock.

Turn your car’s ignition key to the ACC or ON

position.

Press [SOURCE] (PWR).
When the power is switched on for the fi rst time,

a demonstration appears on the display.

Press [DISP] (display) to change to regular

mode.

1

Press [DISP] (display).

2

Press and hold [DISP] (display) again for more

than 2 seconds.

Hours:

3

Press [

%] or [$].

4

Press [DISP] (display).

Minutes:

5

Press [

%] or [$].

6

Press [DISP] (display).

Note:
≥ “ADJUST” is displayed before adjusting the clock.
≥ Press and hold [%] or [$] to change numbers

rapidly.

Display Change

Press [DISP] (display).

When the power is off:

Hours blink

Hours set

Minutes blink

Minutes set

Complete

Clock display

Display off

Clock display

Clock Setting

This manual is related to the following products: